Palfinger PK 23002, Operator'S Manual

Page: 67 / 94

Additional equipment 4.3-6
4.3-6 Raised stand, raised seat
To climb up to the raised seat or raised stand the aids provided must be used (ladder, handles). Make
sure that you do not activate any controls when climbing up.
When working from the raised seat always ensure that there is enough
clearance between the raised seat and the load (see 1.3-1).
• The handles, steps and standing areas are to be kept free of dirt, oil and ice (danger of slipping!).
If necessary they are to be cleaned before climbing up.
• After entering the control stand the respective safety devices to prevent falling (belt, bar, rope)
must be used (closed, applied).
When working on the raised stand ensure that you are never in the
danger area of the crane, in particular below the suspended load or
under or near moving crane components. While performing crane
movements therefore always keep the required safe distance from the
load and crane components. If this distance is not maintained you will
be in acute danger of fatal injury!
Raised stand slewing limiter
If your crane is equipped with a raised stand slewing limiter (see also 4.2-
3), the area over the control stand is blocked during crane operation from
the raised stand.