F.
PNP (optional) – The Transmission Range Switch (PRND) switch is mounted to the
side of the transaxle and is part of the Park Neutral Position (PNP) switch. The PRND
switch is used by the PCM to indicate the actual gear selected. The PRND is made up of
4 individual switches. The scan tool indicates ON or OFF for each switch depending on
the position of the gear selector lever. The combination of ONs and OFFs will indicate
the gear selected. If the combination of ONs and OFFs is invalid, a DTC is set.
G.
TO STARTER RELAY (optional) - This circuit is used to connect the neutral safety
switch to the starter relay terminal #85 (omit this circuit if using anything other than an
electronic automatic transmission). Connect this wire to the circuit in terminal #85 of
the starter relay. DO NOT CONNECT THIS CIRCUIT DIRECTLY TO THE STARTER
SOLENOID.
You can substitute Painless part #30202 (Hot Shot Relay) if the stock
starter relay is not available.
H.
TRANS (optional) – These circuits are used by the PCM to determine vehicle speed,
gear position and control shift patterns.
WIRE COLOR # OF POSITIONS LABELED CONNECT TO:
IN CONNECTOR
TABLE 6.3 Tail Section Connections
FIGURE 6.24 VSS Sensor (4L60E) FIGURE 6.25 VSS & Input Speed Sensor,
Transmission Connection(4L80E)
17
Blue, Pink/White, Lt.Green, Red,
Yellow/Black, Black, Tan/Black, Brown,
Lt.Blue/White, Red/Black, Yellow, Pink,
White
Pink, Black/White, Purple/ White, Yellow,
Lt.Green
Black/ White, Gray, White, Yellow
Red/ Black, Blue/ White
Lt.Green/ Black, Purple/ White
Gray
Purple/ White
Lt.Green
Yellow
13
5
4
2
2
TRANS
PNP
PNP
INPUT SPEED SEN
VSS SEN
FUEL PUMP
FROM START SWITCH
BACK-UP
TO START RELAY
Transmission
Park Neutral Position
Sensor
Park Neutral Position
Sensor
Input Speed Sensor
Output Speed Sensor
Fuel Pump B+
Start Switch
Back-up Light Bulbs
Starter Relay Activation