User’s Manual
8
NOTE:
Up to 128 presets can be set, depending on the specification of installed PTZ devices or dome cameras.
Make sure available preset numbers first to make the PTZ preset function work properly.
NOTE:
If you want to set up the advanced PTZ control, place the cursor on the PTZ control panel, and click the
right mouse button. Depending on the camera specifications, some features may not be supported.
y
Speed:
Set the pan/tilt speed (from 1 to 16). The higher the number, the faster it moves.
y
Move to origin:
Click the button if you want to move the camera to the origin position.
y
Auto
Panning:
Enables or disables auto panning.
y
Camera:
Turns on or turns off the camera.
y
Menu:
Enables or disables the menu function.
y
Pump / Wiper / Light / Aux:
Enables or disables pump, wiper, light and other available functions.
Alarm Control
Clicking the alarm icon
button causes the alarm control buttons to display as shown below. The user can
check the alarm status and control the alarm output. Pressed alarm button is active mode, and released button is
inactive mode. The user can active or inactive alarm output manually by clicking the button when it is released or
pressed. If the user disables the alarm during the Alarm setup on the SmartGuard, the alarm button will be disabled.
Click the left or right arrow buttons to display the previous or next alarm button panel.
POS
Clicking the POS icon
button causes the POS control buttons to display as shown below. The system
status window will display the POS data. Click the right mouse button on the window to toggle two display modes:
POS data display mode, and event log including POS data display mode. The POS button LED will be lit while the
data is coming from the POS. If you do not want to display the data from the POS, release the target POS number
button. If the user disables the POS device during the Text-In setup on the SmartGuard, the POS button will be
disabled.