Packard Bell EasyNote LS11HR, Service Manual

Page: 100 / 218

3-24 Machine Maintenance Procedures
11. Peel back mylar and remove four (4) screws (F) from support plate (G).
12. Slide support plate (G) to release flanges from support plate slots.
NOTE:
NOTE
:
Make sure not to damage keyboard FPC cable when removing keyboard support plate.
13. Remove support plate (G).
14. Remove keyboard from upper cover.
Figure 3-21. Keyboard
Upper Cover/Keyboard Installation
0
1.
Place keyboard onto upper cover.
2. Feed cable (B) through support plate opening (H). Lower support plate (G) into place
(Figure 3-21).
3. Slide support plate hinges into upper cover slots.
4. Install and secure four (4) screws (F) to support plate (G). Cover with mylar.
5. Install and secure three (3) screws (E) to support plate (G). Cover with mylar.
6. Install and secure three (3) screws (D) to support plate (G).
7. Hold keyboard in an angle above computer and connect FPC cable (B) to mainboard
(
Figure 3-20 ) .
8. Lower keyboard into place and press on edges to secure.
9. Connect power board FFC cable (C) to mainboard ( Figure 3-19 ) .
10. Install and secure four (4) screws (B) to battery bay ( Figure 3-18 ).
11. Install and secure eleven (11) screws (A) ( Figure 3-18 ).
12. Install palmrest.
D
D
F
F
F
F
E
E
E
H
B
G