Packard Bell DOTMA-111G16i, Service Manual

Page: 34 / 176

24 Chapter 2
Changing a Password
1. Use the
↑
and
↓
keys to highlight the Set Supervisor Password parameter and press the Enter key. The
Set Password box appears.
2. Type the current password in the Enter Current Password field and press Enter .
3. Type a password in the Enter New Password field. Retype the password in the Confirm New Password
field.
4. Press Enter . After setting the password, the computer sets the User Password parameter to “Set”.
5. If desired, you can enable the Password on boot parameter.
6. When you are done, press F10 to save the changes and exit the BIOS Setup Utility.
If the verification is OK, the screen will display as following.
The password setting is complete after the user presses Enter .
If the current password entered does not match the actual current password, the screen will show you the
Setup Warning.
If the new password and confirm new password strings do not match, the screen displays the following
message.
S e t S u p e r v i s o r P a s s w o r d
E n t e r C u r r e n t P a s s w o r d [ ] [ ]
E n t e r N e w P a s s w o r d [ ]
C o n f i r m N e w P a s s w o r d [ ] [ ]
S e t u p N o t i c e
C h a n g e s h a v e b e e n s a v e d .
[ C o n t i n u e ] [ C o n t i n u e ]
S e t u p W a r n i n g
I n v a l i d P a s s w o r d .
[ C o n t i n u e ] [ C o n t i n u e ]
S e t u p W a r n i n g
P a s s w o r d s d o n o t m a t c h .
R e - e n t e r p a s s w o r d .
[ C o n t i n u e ] [ C o n t i n u e ]
Downloaded from LpManual.com Manuals