51
OPERATION
5. The Digital Readout will now display a “Profile =“
message with the current profile number. To select the
profile number you wish to use, do one of the following:
NOTE
The Timed Mode Remove Light will now be illuminated. A Save Current
Profile? message may be displayed on the Digital Readout if the last
profile used was not stored in memory. If so, press and release the YES
or NO Key at this point. Use the YES Key if you have entered a new profile
or changed a profile you wish to save. Additional message displays will
step you through the save process.
Figure 58.
Figure 59.
6. Adjust the vacuum cup to a point where the bottom
of the vacuum cup is flush with the bottom edge of
the nozzle using the Vacuum Pick Adjust Control.
7. Lower the nozzle to a point .76-1.27mm (.030-
.050”) above the PCB when using Box or Pattern
nozzles. Lower the nozzle to contact a BGA
component.
a) Press and release the STEP Key to advance to
the next higher profile number.
b) Press and release the BACK Key to advance to
the next lower profile number.
NOTE
a & b will not work if "Profile = _ _".
or
a1)Press and release the RECALL Key.
b1)A “Recall - -” message will now be displayed.
c1)Enter the desired 2 digit profile number.
d1)Press and release the ENTER Key.
Summary of Contents for PROGRAMMABLE THERMOFLO
Page 2: ...i MANUAL NO 5050 0420 REV A...
Page 26: ...21 QUICK START...
