45
OPERATION
7. If replacing a BGA component with the ThermoFlo
handpiece mounted on a work platform, do the
following:
a) Place the Alignment Template over the land
pattern.
b) Align the template until the perimeter of the land
pattern is centered inside of the template.
c) Lower the handpiece (with nozzle) until it is
slightly above the PCB assembly rework area.
d) Adjust the PCB to center nozzle squarely over
template.
e) Raise handpiece from PCB.
f) Remove Alignment Template.
Figure 48.
Summary of Contents for PROGRAMMABLE THERMOFLO
Page 2: ...i MANUAL NO 5050 0420 REV A...
Page 26: ...21 QUICK START...
