10
SET-UP
ELECTRICAL REQUIREMENTS
The ThermoFlo unit draws 575 Watts, which is listed on the nameplate on the power source rear panel. A
separate, dedicated AC supply line circuit may be required to adequately power the unit/system. If your power
outlet cannot provide suitable power, arrange for a qualified, licensed electrician to install one for you.
SYSTEM SET-UP
Set up the ThermoFlo unit using the following steps and associated drawings.
1. Remove the ThermoFlo from its shipping container(s). Store the shipping container(s) in a
convenient location. Reuse of these containers will prevent damage if you ship or store the system.
2. Set the ThermoFlo unit on a convenient work bench.
3. Place the POWER Switch (on power source rear panel) in the
"OFF" or "0" position.
4. Inspect all system components to check for shipping damage and to
ensure that all purchased components (standard and options) are
present. Use the drawings provided in the following pages as a
guide for checking the parts that come with the unit. For purchased
options, use the ThermoFlo Accessory Manual (P/N 5050-0421)
supplied with them.
Figure 4.
Summary of Contents for PROGRAMMABLE THERMOFLO
Page 2: ...i MANUAL NO 5050 0420 REV A...
Page 26: ...21 QUICK START...
