71
will change to the default value of “3” for °C (“6” for
°F).
To exit Temperature Setback Mode for all Channels, do either
of the following.
3. Press and hold the Scroll Down Key; press the
Scroll Up Key. Release both keys. This is the
preferred method.
4. Method "3" is preferred but you can turn the
POWER
Switch “OFF” (0) and then back “ON” (1). Set Tip
Temperature and TIP OFFSET CONSTANTs will be
simultaneously restored on all channels.
FACTORY DEFAULT
As received from the factory, the system will not go into
Automatic Temperature Setback. To enable this feature, refer
to the “Calibration” portion of this manual.
Figure 95. Exit Setback Mode
Figure 96. Power Off
Summary of Contents for PRC 2000
