KNOW YOUR PRODUCT
SETUP & PREPARATION
1. ASSEMBLY
1. Water Inlet Connector
2. Motor Housing
3. Hose Clip
4. Telescopic Shaft
5. Additional Handle
6. Speed Controller
7. Rear Handle
8. Battery Seating
9. On/Off Trigger
10. Forward/Reverse Switch
11. Knob
12. Nylon Brush
13. Brush Cover
14. Splash Guard
15. Shaft Collar
SURFACE BRUSH
1
2
3
4
5
6
7
8
BATTERY & CHARGER
This tool is compatible with all battery and chargers from the Ozito
Power X Change Range.
ONLINE MANUAL
Scan this QR Code with your
mobile device to take you to the
online manual.
10
11
9
WARNING!:
ENSURE THE TOOL IS SWITCHED
OFF AND THE BATTERY DISCONNECTED BEFORE
PERFORMING ANY OF THE FOLLOWING TASKS.
Fitting the Additional Handle
For transport reasons the Main Handle is at 90
°
to the brush housing. To
ensure that you have a comfortable working position, the main handle must
be aligned with the brush housing and the length of the Telescopic Shaft can
be adjusted.
1. Unscrew the two knobs on the
handle and separate the handle
from the bracket.
2. Place the top half in position and
secure in place with the bracket
on the underside and the two
knobs.
3. Tighten the two knobs to hold the
additional handle in position.
Note:
To adjust the position, simple loosen the two knobs sufficiently to
allow handle adjustment into the desired position, then tighten the two knobs
to secure in place.
1. Turn the Lock Nut anti-clockwise
to loosen and turn the Main
Handle 90
°
into alignment with
the brush housing.
2. To change the working height,
extended the Telescopic Shaft
to the desired height and then
retighten the Lock Nut by turning
it clockwise.
12
13
14
15
Adjusting the Working Height
