CLOSED
OPEN
3. PREPARATION
4. Attach the brush covers back in
place. The wider brush cover is
used with the Medium Nylon
Brush with the side brush.
1. Run water through your garden
hose to remove any foreign matter
before attaching to the water inlet.
Note:
Do not use water that is
dirty, gritty or contains any chemical
products, as these could impair
operation and shorten the life of the
Surface Brush.
2. Pass a water hose (minimum Ø13mm
(½“), through the Additional Handle
and attach to the Water Inlet Connector
on the unit. Secure the hose to the
Telescopic Shaft with provided Hose
Clip.
Note:
Always use a reinforced hose with
a standard hose coupling for water inlet.
To achieve top cleaning results quickly, use wet cleaning. Hose not included.
This Surface Brush requires a pressurised water source with a maximum
pressure of 87 psi (6 bar). It is recommended that a reinforced garden hose
(with minimum diameter of 12mm) is used for the inlet connection. It cannot
be used with a bucket and siphon.
Water Inlet Connector
5. The
Soft Nylon Brush
(yellow/green) and the
Ultra
Metal Brush
is fitted the
same way, but do not have a side
brush. In this case both narrow
brush covers must be used.
6. To remove brushes, first remove
both Brush Covers on the sides.
Press the middle of the Rubber
Caps to release and pull the
brush to remove at the same
time.
Water Control Valve
The Water Control Valve can be fitted
on the Water Inlet Connector before
attaching your hose. The Water
Control Valve can be opened or in the
closed position as required to control
the flow of water to the cleaning
brush.
WARNING!:
ENSURE BOTH THE WATER SUPPLY
AND THE TOOL IS SWITCHED OFF AND THE
BATTERY DISCONNECTED BEFORE CONNECTING AND
DISCONNECTING THE WATER HOSE.
TAKE CARE NOT TO SPRAY WATER INTO THE MOTOR
VENTS ON THE SIDE OF THE MOTOR HOUSING. IF ANY
WATER DOES GET IT, LEAVE IN A COOL DRY PLACE TO
COMPLETELY DRY OUT BEFORE SWITCHING THE TOOL ON.
