OPERATION (cont.)
Overload protection
When the Surface Brush is overloaded, e.g by pressing too strongly, the
Surface Brush switches off automatically and must be switched on again by
squeezing the On/Off Trigger.
Brushing Artificial Turf
1. Place the Soft Nylon Brush evenly on the surface.
2. Set the working height to the one which is most comfortable for you (see
Adjusting the Working Height
). The Splash Guard must just
clear the ground on both sides.
3. Push Direction Lever hard left. (standard direction of rotation).
4. Lift the equipment 1-2 centimetres and switch on the Surface Brush (see
Switching On and Off
).
5. Set the desired speed (from slow to fast) (see
Variable Speed Dial
).
Wait until the full speed has been reached and then place the brush on
the artificial turf. The Surface Brush will pull away from you.
6. To raise the fibres upright, brush against the direction of the fibres of the
artificial turf once the desired speed has been reached. Do not exert any
pressure.
7. If required, draw the brush towards you and let it roll away without
pressure.
8. Repeat this movement until the desired result has been achieved.
WARNING!:
THE BRUSH COVERS ON THE
SIDE MUST BE FITTED SECURELY BEFORE
USE.
WARNING!
ENSURE THAT YOU HAVE FITTED
THE BRUSH WHICH IS INTENDED TO BE
USED FOR THE SURFACE YOU WANT TO CLEAN.
WARNING!
THE SURFACE TO BE CLEANED
MUST BE FREE OF OBJECTS SUCH AS
STONES, TWIGS, ETC. THESE COULD BE FLUNG
UP BY THE ROTATING BRUSH OR SCRATCH THE
SURFACE.
• Inspect the brushes to check them for dirt before you start your cleaning
work and clean them if necessary.
• Carry out a test run on a small area which is not very visible to check that
brushing does not damage the surface.
• Only use by guiding it over the ground in a vertical position, it should not be
used in a horizontal position (e.g. walls) or overhead (e.g. ceiling). It must
not be used for unmade/unpaved surfaces (e.g. grass pavers).
WARNING!
LIFT THE SURFACE BRUSH 1-2
CENTIMETRES OFF THE GROUND WHEN YOU
SWITCH IT ON, BUT ONLY UNTIL IT HAS REACHED
FULL SPEED. TAKE CARE WHEN DOING SO IN
ORDER TO PREVENT INJURIES.
Cleaning in General (Not artificial turf)
1. Hold the Surface Brush firmly with both hands, ensure the brush is evenly
on the surface.
2. Set the working height to the one which is most comfortable for you (see
Adjusting the Working Height
). The Splash Guard must just clear
the ground on both sides.
3. Select the correct direction of rotation (see
Direction Lever
) for the
surface you want to clean (observe
Cleaning Brushes
section 2).
4. To achieve top cleaning results quickly, we recommend wet cleaning. Open
the water inlet.
5. Lift the equipment 1-2 centimetres and switch on the Surface Brush (see
Switching On and Off
).
6. Set the desired speed (from slow to fast) (see
Variable Speed Dial
).
Wait until the full speed has been reached and then place the brush on the
surface to be cleaned.
7. Guide the brush slowly and in lines, similar to a broom, over the surface.
Only apply a small amount of pressure at first and then increase it little by
little.
WARNING!
ALWAYS WEAR ADEQUATE
PROTECTIVE CLOTHING WHEN OPERATING
THE SURFACE BRUSH TO AVOID INJURIES TO
FACE, EYES, HANDS, FEET AND HEARING.
5. USING THE SURFACE BRUSH
