Wear eye & ear protection
Wear Protective Gloves
Warning
Regulatory Compliance Mark
(RCM)
V
Volts
Hz
W
Hertz
~
n
0
/min
Alternating Current
Watts
No load speed
Revolutions or reciprocations
per minute
Read Instruction Manual
Caution: Hot equipment parts
Wear Protective Closed Footwear
CARING FOR THE ENVIRONMENT
Battery protection system
The tool is equipped with the battery protection system, which helps to ensure a long service
life.
The output power automatically cuts off during operation when the tool and/or battery are
placed under the following situations:
• When the tool is overloaded:
If this occurs, turn off and remove causes of overload, then turn on again to restart.
• When the remaining battery capacity becomes low:
Recharge the battery pack.
Note:
The battery protection system does not in any way damage the tool.
Note:
The indicated capacity may be lower than the actual level during use or immediately
after using the tool.
Power tools that are no longer usable should not be disposed of with household waste
but in an environmentally friendly way. Please recycle where facilities exist. Check
with your local council authority for recycling advice.
Recycling packaging reduces the need for landfill and raw materials. Reuse of recycled
material decreases pollution in the environment. Please recycle packaging where
facilities exist. Check with your local council authority for recycling advice.
Cleaning, maintenance and storing
Cleaning
• Keep all safety devices, air vents and the motor housing free of dirt and dust as far
as possible. Wipe the equipment with a clean cloth or blow it down with compressed
air at low pressure.
• We recommend cleaning the equipment immediately each time after use.
• Clean the equipment regularly with a damp cloth. Do not use cleaning agents or
solvents; these may be aggressive to the plastic parts in the equipment. Ensure that
no water can get into the interior of the equipment. The ingress of water into an
battery power tool increases the risk of an electric shock.
• Remove the safety guard and remove any deposits using a brush.
Maintenance
• There are no other parts inside the equipment which require maintenance
Storage
Store the equipment and its accessories in a dark and dry place at above freezing
temperature. The ideal storage temperature is between 5 and 30 °C. Store the electric
equipment in its original packaging.
Do not bend the rubber lips of the splash guard outwards. Store the equipment in such
a way that the rubber lips are not in contact with the floor/ground as far as possible.
Note:
Ozito Industries will not be responsible for any damage or injuries caused
by the repair of the Surface Brush by an unauthorised person or by mishandling of
the blower vac. This tool is designed for DIY use - use in commercial or industrial
environments will void the warranty.
SPARE PARTS
Spare parts can be ordered from the Special Orders
Desk at your local Bunnings Warehouse.
For further information,visit www.ozito.com.au or
contact Ozito Customer Service:
Australia 1800 069 486
New Zealand 0508 069 486
E-mail: [email protected]
DESCRIPTION OF SYMBOLS
MAINTENANCE
WARNING!:
ENSURE THE TOOL IS SWITCHED
OFF AND THE BATTERY DISCONNECTED BEFORE
PERFORMING ANY OF THE FOLLOWING TASKS.
