2. CLEANING BRUSHES
2. The
Medium Nylon Brush
(black) is supplied with a side
brush. Each of the brushes
have Rubber Caps on the
outside.
3. Slot the nylon brush with
side brush onto the brush
mount on either the left or
right side according to your
requirements and the other
nylon brush onto the other
brush mount.
1. Remove Brush Covers from each
end of the brush housing.
Fitting and Removing the Cleaning Brushes
Use only the brush which is intended to be used for the surface you want to
clean. Test the brush for suitability on an inconspicuous area first before using
it each time. Different brushes for different surfaces are available as separate
accessories. Only use water without any additives whatsoever.
Note:
Worn or frayed brushes should be replaced in good time. Replace the
brush as soon as its diameter is less than approx. 95 mm. A brush diameter of
any less can lead to damage.
•
Medium Nylon Brush - Black
This brush is specifically suitable for cleaning unsealed paver and stone
surfaces. It can therefore also be used for cleaning surfaces which are paved
with paving stones/concrete blocks or concreted surfaces (e.g. driveways,
decks, paths). The side brush can be used for cleaning perimeters and bases.
Diameter: 115mm. Working width: 215mm
Cleaning smooth, unsealed paver and stone surfaces
• Brush in a forward direction only, standard direction of rotation.
• In case of certain kinds of stubborn dirt, it can be helpful to clean using
both directions of rotation. Please note that when the equipment is in
reverse, it has less power.
• To clean perimeters and bases, remove the wide side cover and clean them
using the side brush.
• Afterwards, rinse the cleaned surface down with water.
•
Soft Nylon Brush - Yellow/Green
This brush also be used for cleaning wood, composite materials such as
Bamboo Plastic Composite (BPC) and Wood Plastic Composite (WPC) or for
brushing (e.g. flattened areas) artificial turf to raise it upright, as used in the
home where it is installed, for example, on balconies or decks.
Diameter: 115mm. Working width: 195mm
Cleaning wood, composite materials(BPC/WPC)
• Always clean the boards or wooden elements in a longitudinal direction
(along the grain).
• Brush in a forward direction only, standard direction of rotation.
• It is recommended that you clean on a board-by-board basis.
• Afterwards, rinse the cleaned surface down with water.
Brushing artificial turf
• Do not use water - dry-brush only.
• Brush in a forward direction only, standard direction of rotation.
• Remove all leaves, rubbish and similar before starting brushing.
WARNING!:
ENSURE THE TOOL IS SWITCHED
OFF AND THE BATTERY DISCONNECTED BEFORE
PERFORMING ANY OF THE FOLLOWING TASKS.
•
Ultra Metal Brush (accessory)
This brush can be used for cleaning robust surfaces such as, e.g. paving
stones/ concrete blocks, concreted surfaces, granite or porphyry to remove
stubborn dirt.
Rough, unsealed paving stones, concrete blocks and
concrete surfaces
• Brush in a forward direction only, standard direction of rotation.
• In case of certain kinds of stubborn dirt, it can be helpful to clean using both
directions of rotation. Please note that when the equipment is in reverse, it
has less power. Afterwards, rinse the cleaned surface down with water.
• Not suitable for polished, ground or sealed natural/artificial stone surfaces.
WARNING!:
THE SURFACES MUST BE SUITABLE FOR
CLEANING USING ROTATING BRUSHES. FOR WET
CLEANING THE SURFACES MUST ALSO BE INSENSITIVE
TO WATER.
WARNING!:
SENSITIVE, POLISHED, COATED AND
SCRATCH-SENSITIVE SURFACES CAN BECOME
ROUGHENED AND/OR GET DAMAGED. THIS EQUIPMENT
MUST NOT BE USED TO CLEAN SUCH SURFACES.
WARNING!:
THERE IS A RISK OF INJURY FROM THE
BRISTLES - WEAR SAFETY GLOVES.
WARNING!:
THERE IS A RISK OF INJURY FROM THE
BRISTLES - WEAR SAFETY GLOVES.
