REV
FWD
REV
FWD
REV
FWD
REV
FWD
PXSBS-018
OPERATION
1. Align the ribs of the battery with
the battery mount and slide in
until it clicks into place
2. To remove, press and hold the
battery release tab and then slide
out.
Inserting & Removing the Battery
Switching On and Off
1. To switch ON, squeeze the
On/Off Trigger, the cleaning brush
will rotate.
2. To stop the cleaning brush
rotating, release the On/Off
Trigger.
Variable Speed Dial
To adjust the speed of the cleaning brush, rotate the variable speed dial. This
allows the speed to be adjusted to the particular surface being cleaned.
The dial is marked
MIN = slowest \ MAX = highest.
“1” to “5”. setting to indicate the set
speed.
4. CONTROLS
Direction Lever
Using the Direction Lever you can select the direction of rotation of the
cleaning brush and lock it so that it cannot be switched on accidentally. You
can select between forward and reverse rotation. Forward is the standard
direction of rotation, with which the unit has the most power.
Note:
Hold the Surface Brush firmly by the handle and additional handle and
make sure you have a steady standing position.
Note:
To avoid causing damage to the Surface Brush, the direction of
rotation must only be changed when the cleaning brush is at a standstill.
1. Forward - standard direction of
rotation: Push Direction Lever
hard left. The Surface Brush pulls
away from you.
2. Safety Lock-off: Direction Lever
in the middle position. On/Off
Trigger locked.
3. Reverse: Push Direction Lever
hard right. The Surface Brush
moves towards you.
WARNING!:
KEEP YOUR HANDS AND FEET AWAY
FROM THE ROTATING CLEANING BRUSH.
WARNING!:
ONLY INSERT THE BATTERY JUST
BEFORE YOU START YOUR WORK AND REMOVE IT
AGAIN WHEN YOU HAVE FINISHED.
WARNING!:
TAKE CARE NOT TO EXPOSE THE
BATTERIES TO ANY WATER DURING USE. THE
BATTERY MUST NEVER BE SUBMERGED IN WATER.
WHEN NOT IN USE, THE BATTERY SHOULD BE STORED
IN A COOL AND DRY PLACE. IF THE BATTERY IS HEAVILY
SPRAYED WITH WATER OR ACCIDENTALLY SUBMERGED,
STOP USING THE BATTERY IMMEDIATELY.
