1
4. PREPARATION CONT.
6 Return priming lever to
spray position.
5 Wait for air bubbles to clear
return pipe, this is indicated
by a steady stream of paint
out of return pipe.
7 Wait for the Airless Sprayer to automatically cut out, after a few
moments. The sprayer is now ready to use.
Note:
If the Airless Sprayer does not shut off automatically, repeat
steps 4 to 7.
Aligning Spray
1 Refer to section 7 Pressure
Release. Then rotate the
spray guard to match the
direction of preferred spray
pattern.
Setting Pressure
1 Set the pressure control
dial to a medium - high
pressure.
2 Test this pressure setting
on a scrap piece of
material.
3 Adjust the pressure setting until a smooth even consistency is
achieved.
Note:
The spraying result depends considerably on how well
prepared the surface is for painting. Carefully complete proper
surface preparation for painting before beginning to spray.
Speed
1 On a scrap piece of
material, spray a test patch
assessing the speed of
stroke required for pressure
setting. Lower pressure
will require slower speeds
and higher pressure faster
speeds.
5. TEST SETTINGS
OPERATION
HP
LP
Fast
Slow
vertical
Horizontal
