10. General Maintenance Issues
42 |
P a g e
10.4 Coolant Control
A coolant is put to use in case OMRM 121 Automatic end milling machine is
purchased with an aluminum cutting option.
10.5 Conditioner Water Level Control
There must be no water in the glass tube on the left side of conditioner (reservoir no. 1). Any
accumulated water should be discharged.
For this, you may press the plug under the tube upward or rotate it, depending on the type of
the conditioner used for the machine.
10.6 Conditioner Oil Level Control
Check oil level within the transparent tube located on the right hand side of conditioner. If the
oil runs out, cut the air of the machine and put oil into the conditioner. When oil amount is low,
replenish using oil types equivalent to Shell TELLUS C 10.
1
2
Summary of Contents for OMRM 121
