8. Machine Installation
25 |
P a g e
8. Machine Installation
Expert M.S.K. personnel will carry out all procedures with regard to loading and unloading and
conduct performance tests for assembly, mounting and start-up, if necessary. These procedures
are evaluated on machine basis and carried out for products deemed necessary. Setting up of
parts and equipment which should be prepared prior to machine use must be performed.
Required operations will be explained below.
8.1. Machine Placement
Use predefined hanger lifting points to position the machine at the site described in the plant
layout. You may adopt previously exemplified transport methods. Using any other method may
damage your machine.
8.2 Fixing on Ground
The machine must be placed considering the maintenance and operating spaces. Rear and side
spaces and spaces recommended for maintenance procedures are above-mentioned. An
expansion bolt at a size of M12X50 mm is recommended for floor connection.
8.3 Start-up Preparation
Moving parts of the machine are generally cleaned by an anti-rust oil. Power connection and
pneumatic connection are made for the machine to function properly.
8.4 Electrical Connections
VOLT
400 V
HERTZ
50 Hz
CURRENT
2.4 A
POLE
3P+N+E
Summary of Contents for OMRM 121
