6.Use the Multimeter (Optional)
113
Making Relative Measurements
When making relative measurements, reading is the difference between a stored
reference value and the input signal.
(1) Select
Configure
in the bottom menu, select
Relative
in the right menu to
enter the relative mode.
The measurement value at this time is stored as the reference value, and
displayed behind
△
.
In this mode, current reading = input value - reference value.
(2) Press it again to exit the mode.
Note
: This function is not available when measuring resistance, diodes, and
testing for continuity.
Information Display
Show/hide the information window on the top right of the display.
(1) Select
Configure
in the bottom menu, select
Show Info
in the right menu as
ON
. The information window will be shown on the display.
(2) Select
OFF
to hide.
Auto or Manual Range
Auto range is set as default. To switch auto or manual range, do the following
steps:
(1) Select
Configure
in the bottom menu.
(2) Select
Auto Range
in the right menu,
AUTO
will be shown on the display.
(3) Select
Switch Range
in the right menu,
MANUAL
will be shown on the display.
Press this softkey to switch range.
Note
: When testing diode, testing continuity, and measuring capacitance, manual
range is disabled.
Multimeter Recorder
You can use the multimeter data recorder to record the measurements when
measuring current/voltage by multimeter (optional).
Push the
Utility
button, select
Function
in the bottom menu, select
DAQ
in the left
menu.
The description of
DAQ
Menu
is shown as the follows:
