NEO S-Series User Guide
10400666-001
© 2014 Overland Storage, Inc.
Page 15
Emergency release
3.4
NOTE
Use only in emergency fall
The emergency release is similar for all library unit heights..
If you cannot remove the complete magazines via the OCP or RMU, do the following:
1.
Press the power button on the front bezel to power down the library.
2.
Unplug the power cord from the library.
3.
From the rear panel of the library, find the access holes for the right and left magazines.
Figure 2
Rear panel (access holes)
1 - Access hole for the right magazines
2 - Access hole for the left magazines
4.
Push the end of a small metal pin or straightened paper clip into the magazine access hole at the back of the device.
While holding the pin or clip, have a second person attempt to pull the magazine out of the front of the unit.
For the 4U, all magazines on a side are released and should be removed at the same time.
Figure 3
4U Front panel (magazine remove)
5.
If necessary, repeat the steps 3 and 4 for the other magazine.
6.
If other tape cartridges are still in the library, or if you were unable to manually remove the magazines and tape
drive, contact the service for further instructions. See
Chapter Contacting , Page
Error! Bookmark not defined..
Upgrade the library firmware
3.5
The firmware version for the libraries must be compatible with all implemented devices. Verify that the library has the
latest released version of firmware loaded.
