Overland Storage LXLS10, User & Installation Manual

Page: 69 / 90

Troubleshooting
t
5-7
F
AULT
S
YMPTOM
C
ODES
(FSC)
2006 DRV Comm. Open
Error
Enter to Reboot or
Power Down to Clear HARD fault - Unable to open the serial port
to the drive. The loopback test of the baud
rate divisor registers or one of the "expected
0" bit tests failed. C, D, G
2007 Door Fault
Press Enter to Clear
SOFT fault - A door err was detected -
unused in LTO. F
2008 Illegal Move
Press Enter to Clear SOFT fault - A move media command was
requested from an empty source or to an
occupied destination. F
2009 Door Open
Press Enter to Clear
SOFT fault - The door is open - unused.
Status Only
200A Menu Mode
Press Enter to Clear
Used to inform the Web TLC that the
commanded action cannot be performed
because the loader is in the menu mode due
to a front panel request.Status Only
200B Watch Dog Muzzled
Enter to Reboot or
Power Down to Clear
HARD fault - Watch Dog muzzle in place -
unused in LTO C, D, G
200C Cart Unaccessible
Press Enter to Clear
Used to inform the Web TLC that the move
medium command (from drive) cannot be
honored because the explicit unload mode is
set. F
200D Drive In Error
Press Enter to Clear
Used to inform the Web TLC that the drive
cannot be loaded or unloaded due to a drive
fault. F
200E No Magazine
Press Enter to Clear SOFT fault - The magazine is not installed. F
200F Removal Prevented
Press Enter to Clear SOFT fault - medium removal prevented by
drive. F
2010 Ctl. Firmware Error
Enter to Reboot or
Power Down to Clear HARD fault - Firmware failure detected in
control process. C, D, G
2011 Ctl. Firmware Error
Enter to Reboot or
Power Down to Clear HARD fault - Firmware failure detected in
control process. C, D, G
2012 Ctl. Firmware Error
Enter to Reboot or
Power Down to Clear HARD fault - Firmware failure detected in
control process. C, D, G
Table 5-2. Fault Symptom Codes