12
For Help, call 1-800-784-5028 or visit www.overheaddoor.com
C
HECKING THE
F
ORCE
L
IMIT
Settings Step 7:
A
Test contact reverse.
•
Open door using Wall Control.
•
Lay 2" x 4" board on floor in center of garage door
opening (Figure 14).
•
Close door using Wall Control.
–
Door should stop and reverse within 2 seconds of
contacting the board.
–
If door does not reverse properly, repeat Setting
Steps 1 and 2 on pages 9 and 10.
–
If door still won’t reverse properly, contact Customer
Service at 800-784-5028.
FCC and IC CERTIFIED
This device complies with FCC Part 15 and RSS 210
of Industry Canada. In accordance with FCC
Regulations, this device has no right to be
protected from interference by other legal radio
transmissions. Accordingly, it is possible that
military or other civilian radio transmissions
operating on a similar frequency could interfere
with the radio transmission between the remote
transmitter and the receiver in this device. This
equipment has been tested and found to comply
with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against harmful interference in a residential
installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may
cause harmful interference to radio
communications. However, there is no guarantee
that interference will not occur in a particular
installation. If this equipment does cause harmful
interference to radio or television reception, which
may be determined by turning the equipment off
and on, the user is encouraged to try to correct the
interference by one or more of the following
measures:
• Re-orient or relocate the receiver antenna.
• Increase the separation between the operator
and receiver.
• Connect the operator into an outlet on a
circuit different from that to which the receiver
is connected.
• Consult your local dealer.
Figure 14 Checking force limit.
ABOUT DUAL FREQUENCY
REMOTE TRANSMITTERS
Your garage door opener (GDO) features a
unique dual frequency remote control system
for reliable service in today’s crowded airwaves.
Overcrowded airwaves may intermittently
interfere with GDO’s remote control system.
The dual frequency feature greatly reduces the
possibility of unwanted interference.
The receiver in the GDO’s powerhead can
receive signals at 315 AND 390 MHz. The
remote is factory set at 315 MHz. See Figures
13A and 13B for frequency selector switch.
Switch your remote control frequency when:
• Remote does not have adequate range.
• Remote works inconsistently with fresh
battery installed - LED feedback lights up
when pressing button.
• Programming your car’s HomeLink® system.
To program a HomeLink® device:
(This GDO is HomeLink® compatible.)
• Use a small flat screwdriver to switch the
frequency selector to 390 MHz.
• Follow the HomeLink® instructions in your
car owner’s manual.
• Reset the remote control frequency to
315 MHz for everyday use.
Downloaded from
www.Manualslib.com
manuals search engine
