10
For Help, call 1-800-784-5028 or visit www.overheaddoor.com
S
ETTING
/
ADJUSTING THE
B
OTTOM
E
ND OF
T
RAVEL
Settings Step 2:
A
Wait a short time until “2”starts flashing. Press button C. The
door will travel in the CLOSE direction as long as the button is
pressed. Release button C when door is within two inches of
floor. Use B and C buttons to make final adjustments. Figure 11.
B
Once the desired CLOSE end-of-travel position has been
reached, press the D button.The opener stores the CLOSE
end-of-travel position.
•
“0” is displayed.
P
ROGRAMMING THE
R
EMOTE
C
ONTROL
Settings Step 3:
A
Briefly press button D. Figure 12.
•
“3” is displayed.
B
When the display begins to flash, press the desired button on
the remote for one second, then release the button for one
second. Continue pressing and releasing the same button
until decimal point begins to flash.
•
Additional transmitters (up to 7) can be programmed by
following the same procedure.
C
To operate the remote control.
•
Press the remote button once.
–
The door will move.
•
Press the same button again.
–
The door will stop.
•
Press the same button again.
–
The door will move in the opposite direction.
The
door will stop automatically at the fully open or
fully closed position.
A
B
P
ROGRAMMING
M
ULTI
-
BUTTON
R
EMOTE
C
ONTROLS
Settings Step 4:
A
Programming.
•
For each button.
–
Program as one-button transmitter above.
B
Operation.
•
Same as one-button.
NOTE
Each button on a multi-button remote is designed for
use with 1 door. You cannot program 2 buttons to
operate the same door, nor can you program 1 button
to operate 2 doors.
Figure 11 Setting bottom end
Figure 12 Programming Start Function.
A
B
Downloaded from
www.Manualslib.com
manuals search engine
