22
2. Turn the Head Lever to
OPEN
position, and then pull out the Ribbon Module.
NOTES:
1. When the Head Lever is turned incompletely, the Ribbon Module may not be pulled out.
2. Care must be taken not to bend, drop, or hit the Ribbon Module, as this may deform the Ribbon
Module, causing print failures.
3. Remove the two Ribbon Shafts from the Ribbon Module. Remove the Ribbon Stoppers from the
Ribbon Shafts.
4. Insert the Ribbon Shafts into the ribbon cores, aligning the tab of the Ribbon Shaft with the notch
of the ribbon core.
5. Fit the Ribbon Stoppers onto the Ribbon Shafts, aligning the rib of the Ribbon Stopper with the
groove of the Ribbon Shaft.
NOTE
: Do not fit the Ribbon Stoppers by force, as this may damage the Ribbon Stoppers.
Head Lever
Ribbon Module
Ribbon Shaft
Ribbon Stopper
Tab
Notch
Ribbon Shaft
Ribbon Core
Ribbon Shaft
Ribbon Stopper
Ribbon Shaft
