CONNECTIONS AND INSTALLATION
OPTIONAL UPGRADES
18
11
OUTBACKGUIDANCE.COM
OUTBACKGUIDANCE.COM
Routing the Antenna Cable
Adhere to the following when routing the antenna cable:
• Make sure the REBEL terminal is powered off before attaching the cables.
• Do not bend the cable to a radius of less than 6 inches.
• Do not route the cable within 12 inches of radio wires, power generator wires, a heat source, or moving
parts.
• Coil excess cable in a protected location and secure the installation with tie straps.
To route the antenna cable:
1. Securely attach one end of the antenna cable to the antenna.
2. Route the cable through a cab opening where rubber protection exists that
will protect the cable (see photo at right).
3. Attach the other end of the antenna cable to the terminal (see "REBEL
Terminal Overview" on page 13 and "REBEL Connection Diagrams"
starting on page 14).
Installing Optional Parts
A camera is not included in your REBEL kit; you must purchase that separately (not sold by Outback Guidance).
Follow the camera manufacturer's instructions for installing your cameras.
To install the foot switch, rover radio, lightbar, switchbox, or connect to the ISOBUS ECU see the sections that
follow.
Installing the Foot Switch
Use the foot switch as a remote to pause or restart REBEL's mapping/data logging function (similar to pressing
Apply on the touchscreen-refer to the Help on the REBEL terminal for more information on the Apply button).
Using "REBEL Terminal Overview" on page 13 and "REBEL Connection Diagrams" starting on page 14 as guides,
install the foot switch:
1. Connect the foot switch cable of the COM2 cable to the foot switch.
2. Install the foot switch in an easily accessible position.
Installing the Rover Radio
Mount the rover radio on top of the vehicle cab to ensure line-of-sight to the RTK base station. The bottom of the
rover radio includes a built-in magnet for easy placement on the included mounting plate.
1. Clean and dry the vehicle surface where you will attach the rover radio
mounting plate.
2. Remove the paper backing from the adhesive strips on the back of the
mounting plate (see photo at right).
3. Position the mounting plate and press down hard for proper adhesion.
4. Place the rover radio on the plate.
5. Attach the rover radio antenna to the rover radio, tightening until snug.
Camera Kit Contents (optional)
Unpack your camera kit and identify the parts as shown. Contact your dealer for supported camera models.
Part Number
Qty
Description
Photograph
050-0021-01
1
LAN/USB cable
Connects LAN/USB port on terminal to
eDriveXC/XD cable and camera
ISOBUS Cable Kit Contents (optional)
Unpack your ISOBUS cable kit and identify the parts as shown. See "Connecting to Your ISOBUS ECU" on
page 20 for instructions on connecting this cable.
050-0042-01
1
COM2 cable
Connects COM2 port on terminal to
ISOBUS extension cable and foot switch
ISOBUS Extension Cable Kit Contents (optional)
Unpack your ISOBUS extension cable kit and identify the parts as shown. See "Connecting to Your ISOBUS ECU"
on page 20 for instructions on connecting this cable.
Part Number
Qty
Description
Photograph
Part Number
Qty
Description
Photograph
054-0197-000#
1
ISOBUS extension cable
Connects the ISOBUS connector on
ISOBUS cable to the ISOBUS connector
on your vehicle