CONNECTIONS AND INSTALLATION
OPTIONAL UPGRADES
20
9
OUTBACKGUIDANCE.COM
OUTBACKGUIDANCE.COM
Connecting to Your ISOBUS ECU
If your vehicle is ISOBUS-ready see "ISOBUS-Ready Vehicle Connections" immediately following. If your vehicle is
not ISOBUS-ready see "Non ISOBUS-Ready Vehicle Connections" starting further below.
ISOBUS-Ready Vehicle Connections
1. Locate the ISOBUS connector in the tractor cab. Typically, the connector is a 4-pin female Deutsch
connector and is found behind the access panel on the right side of the cab.
2. Using "Connection Diagram #2 - With
ISOBUS" on page 15 as a guide, connect the
4-pin male Deutsch (ISOBUS) connector on
the COM2 cable to the tractor ISOBUS
connector.
Switchbox Kit Contents (optional)
Unpack your switchbox kit and identify the part as shown. See "Installing the Switchbox" on page 1 for instructions
on installing the switchbox in your preferred location.
Part Number
Qty
Description
Photograph
806-1035-000#
1
Switchbox
604-0019-000#
1
Suction cup mounting kit
If an ISOBUS extension cable is needed
(COM2 cable does not reach the tractor
ISOBUS connector) or the ISOBUS
connector is something other than a 4-pin
Deutsch female connector, use the ISOBUS
extension cable.
4-pin male Deutsch connector
(part of COM2 cable)
4-
pin female Deutsch connector
(in tractor cab)
Foot Switch Kit Contents (optional)
Unpack your foot switch kit and identify the parts as shown. See "Installing the Foot Switch" on page 18 for
instructions on installing the foot switch in your preferred location.
Non ISOBUS-Ready Vehicle Connections
Non ISOBUS-ready vehicles (that do not have an IBBC connector on the back of the vehicle) require a retrofit kit.
There are two kits available-each with a bracket and two cables (power cable and data/relay cable). The bracket
is the same in each kit; however, the 'Short' kit cables are shorter than the 'Long' kit cables. The power cable
connects to the battery and the data/relay cable connects to the 4-pin male Deutsch connector on the COM2 cable
or on the ISOBUS extension cable.
Note: Tie straps are included in each retrofit kit
—use the straps to secure cables where appropriate.
1. Using "Connection Diagram #2 -
With ISOBUS" on page 15 and
"Connection Diagram #3 - ISOBUS
Retrofit Kit" on page 16 as guides,
connect the data/relay cable (there
are two different data/relay cables;
only the appropriate cable is included
in your kit) to the IBBC bracket. You
will make three connections, one
each in steps a-c below. Use the
diagram at right for reference when
completing steps a-c.
Part Number
Qty
Description
Photograph
720-0035
1
Run/hold foot switch
This kit does not include mounting
hardware (such as fasteners)
