OPTIONAL UPGRADES
CONNECTIONS AND INSTALLATION
12
17
OUTBACKGUIDANCE.COM
OUTBACKGUIDANCE.COM
ISOBUS Retrofit Kit Contents for Non-ISO-Ready Vehicles (optional)
Unpack your ISOBUS retrofit kit and identify the parts as shown. There are two kits available-each with the same
bracket but different cables (the 'Short' kit cables are shorter than the 'Long' kit cables). See "Connecting to Your
ISOBUS ECU" on page 20 for instructions on installing the ISOBUS retrofit kit.
750-0161-000
1
IBBC bracket
Included in both 'Short' and 'Long' kits
Installing REBEL
Note: Proper installation is critical for safe and optimal REBEL operation.
The following steps represent typical installation order; however, install components in your preferred order.
1. Install your autosteering controller (eDriveXC or eDriveXD). See the installation instructions included with
your autosteering controller kit.
2. Install the optional rate/section control controller (AC110). See the installation instructions included with
your rate/section controller kit.
3. Install other optional parts (foot switch, lightbar, switchbox) then route the appropriate cables into the cab
for connection to the terminal.
4. Mount the antenna.
5. Install the terminal mounting hardware both in the cab and on the terminal.
6. Connect the appropriate cables to the terminal.
054-019 2-000#
1
054-019 3-000#
1
054-019 4-000#
1
054-019 5-000#
1
Power cable, 12 ft ('Short' kit)*
Power cable, 21 ft ('Long' kit)*
*Your kit includes one of the above cables
Data/relay cable, 10 ft ('Short kit)*
Data/relay cable, 20 ft ('Long' kit)*
*Your kit includes one of the above cables
7. Connect the terminal to the mounting hardware.
Mounting the Antenna
You should install the antenna on the vehicle's left/right centerline and front/back pivot point. If you cannot install
the antenna at the exact centerline and/or pivot point, refer to REBEL Help installed on your terminal for
instructions on entering offsets for these values.
Do not place the antenna within two feet of a transmitting radio antenna (such as for a 2-way or business band
radio).
1. Clean and dry the vehicle surface where you will attach the antenna
mounting plate.
2. Remove the paper backing from the adhesive on the back of the
mounting plate (see photo at right).
3. Position the mounting plate and press down hard for proper adhesion.
4. Attach the antenna to the antenna mounting base (see photo at right).
Note: The photo at right shows the plastic wrapping still on the
magnetic mount. Before placing the antenna and mount on the vehicle
in the next step, remove the plastic wrapping from the mount.
5. Place the magnetic mounted antenna on the plate and on the vehicle's
centerline and pivot point.
Part Number
Qty
Description
Photograph
