CONNECTIONS AND INSTALLATION
KIT CONTENTS
24
5
OUTBACKGUIDANCE.COM
OUTBACKGUIDANCE.COM
ROW-CROP
Connecting the Cables to the Terminal
Using "REBEL Terminal Overview" on page 13,
"REBEL Connection Diagrams" starting on
page 14, and the photo at right as guides,
connect the appropriate cables to the REBEL
terminal.
Mounting the Terminal
Before you mount the terminal determine an appropriate mounting location. Locate the terminal within easy reach
and visibility of the driver; typically, this is in the front, right corner of the cab. Additionally, allow enough room for
any optional equipment, such as the lightbar and/or switchbox.
Part Number
Qty
Description
Photograph
050-0041-01
1
COM2 cable
Connects COM2 port on terminal to foot
switch
050-0045-01
1
Antenna extension cable
Connects COM1 cable to antenna
050-0046-01
1
Power adapter cable
Connects power cable to power source
720-0033-00A
1
Antenna mount
!
WARNING:
Do not mount the terminal in a location where it interferes with seeing other information, controls,
or the field. Looking at the screen for too long while operating the vehicle can cause a crash.
1.
Use the terminal mounting hardware to mount the
terminal.
Review the terminal mounting hardware (top
photo at right).
2. If necessary, loosen the knob on the arm mount and remove
the ball mounts from the mounting assembly.
Using the bottom photo at right as a guide, complete the following
steps:
3. Attach the round base to the back of the terminal using the
screws provided.
4. Attach the bar mount base to your preferred location using the
included U-bolt hardware.
5. Place one end of the arm mount over the ball of the bar mount
base then tighten the knob enough so the arm mount stays
attached.
6. Position the terminal so the round base fits in the open end of
the arm mount then tighten the knob securely.
7. Adjust the terminal to your preferred viewing angle.
676-0024-000#
1
Antenna mount adapter
607-0023-01
1
Switch bracket
Use to mount eDriveXC power switch
520-0022-01
1
USB drive, 8 GB
484-0002-01
1
Screen protector, 2 pk, with
applicator/cleaner
COM1
COM2
051-0397-10 1
Adapter Cable
