Otto Bock Juvo, Instructions For Use Manual

Page: 19 / 124

If necessary, the qualified personnel can adapt the preprogrammed wheelchair control unit and options to the con­
crete requirements of the user.
6 Use
6.1 Circuit breaker
INFORMATION
► Should the automatic circuit breaker deactivate repeatedly after activation for no discernible reason, contact
the qualified personnel.
► For shipping or when the power wheelchair is not being used for an extended period of time, the automatic
circuit breaker should be deactivated.
The automatic circuit breaker has to be activated before the power wheelchair can be switched on.
It is located under the seat between the drive wheels.
6
Activating the circuit breaker
► Close the reset lever, which is at an angle (see
fig. 6, item 1).
→
The reset lever engages and the circuit breaker is
activated.
Deactivating the circuit breaker
►
Press the pushbutton until the reset lever flips up at
an angle (see fig. 6, item 2).
→ The circuit breaker is deactivated.
6.2 Side panels
The side panels protect the user and his/her clothing from getting dirty.
The installed armrests offer the user additional support for the forearms.
6.2.1 Removing/installing the side panels
To make getting in from the side easier or for transportation, the side panels can be removed if needed.
7
Removing the side panel
1) Loosen the thumb screw on the side panel holder
(see fig. 7, item 1).
2) Pull the side panel out from the side panel holder
and set it aside (see fig. 7, item 2).
3) Only for side panel with control panel:
→ Turn the control device off (see Page 25).
→ Carefully let the side panel with the control pan­
el hang down while getting in.
→ For transporting the power wheelchair, place
the side panel on the seat.
Installing the side panel
1) Insert the side panel into the side panel holder.
2) Re-tighten the thumb screw on the side panel hold­
er (see fig. 7, item 1).
To make getting in from the side easier or for transportation, the side panels can be removed if needed.
19 Juvo
Use