1 Introduction
Service Manual – Osmetech OPTI™ Analyzer
1-1
1 Introduction
General Information
This Service Manual includes information and data necessary for repair and
maintenance of the Osmetech OPTI™ 1 and Osmetech OPTI™ CCA analyzers.
The manual is intended to be used with the Operator’s Manual where operating
instructions and procedures are described. In order to fully utilize the described
procedures in this manual, it is necessary to be familiar with the operation and
handling described in the Operator’s Manual.
To ensure proper operation and performance which meets the analyzer
specifications, maintenance and repairs must be performed according to the
instructions described in this service manual. The use of Osmetech original parts
and recommended materials is required to achieve performance specifications.
Spare parts and the proper order numbers are described in Chapters 7 and 8.
Product warranties may vary by country. Specific warranty terms and conditions
are described in documents provided at the time of installation.
Warnings
Warnings in this manual are marked with CAUTION and describe situations or
potential dangers that may be hazardous to personnel performing maintenance or
service activities. Information marked with NOTE describes situations or
hazards, which can cause damage or analyzer malfunction and should be
avoided. The following general operating conditions should be strictly adhered
to:
•
Never operate the analyzer near flammable or explosive gases.
•
Check the supply voltage before connecting the analyzer to local AC power.
•
When operating the analyzer connected to primary AC power, always
connect it to a properly grounded 3-pole power receptacle.
•
Replace damaged or worn power cables or plugs.
•
Before opening the rear cover, turn off the analyzer, disconnect the power
cable from the primary AC source and remove the battery.
