10279-D01-00
Page 86 of 142
This information is the property of Oshkosh Specialty Vehicles and is considered to be confidential. The contents may not be used, either
partially or wholly, for any purpose inconsistent with which it was produced. This information may not be reproduced or disclosed without prior
express consent.
Transport Warning Strobe Light
If the Transport Warning Strobe Light is flashing the mobile unit must
not be moved. If the mobile unit is moved while this light is flashing,
irreparable damage to the mobile unit, serious personal injury or
death can occur.
The Transport Warning Strobe Light is located on the exterior left side of the mobile unit
and will illuminate when the Platform Lift is not in the proper transport position. It is the
Operator’s responsibility to ensure that the Transport Warning Light is functioning properly
and that the bulb element is in working order. Please refer to the Oshkosh Specialty
Vehicles VOL II Vendor Information binder for the product manual, the Oshkosh Specialty
Vehicles VOL I Service/Operation Manual binder for a list of local service representatives,
or contact Oshkosh Specialty Vehicles for service.
Lift Transport Restraining Cable
The lift Transport Restraining Cable, when installed and connected securely, is designed to
provide a stop gap measure to prevent the lift from falling to the horizontal position should
the lift be improperly stowed.
10.2 Hydraulic
System
An internal hydraulic cylinder controls the movement of the Platform Lift. The cylinder is located in
the compartment below the roll door.
Operation
When the “UP” function has been selected for the Platform Lift, the pump is activated and
fluid is moved from the reservoir through the valve block to the hydraulic cylinder. This
causes the lift to move upward. When the “DOWN” function has been selected for the
Platform Lift, the pump is not activated, but the fluid is moved from the hydraulic cylinder
through the valve block to the reservoir. This causes the Platform Lift to descend.
