Oshkosh Corporation JERR-DAN 20NGADF6T-LP, Operation And Safety Manual

Page: 52 / 112

Section 4 : Operation
4-10 5376000207
5. Adjust the electronic or manual throttle control to set the engine speed
to approximately 1000-1200 R.P.M. Refer to chassis operator’s manual
for proper operation of the auxiliary throttle. If your chassis is equipped
with the remote throttle up option from the chassis manufacturer there
is no need to set the throttle up control in the cab because the
throttle will automatically increase when any of the carrier hydraulic
functions are operated.
Never exceed 1200 R.P.M. When your hook up is complete, reset the
engine idle to normal.
6. Block the carrier’s rear tires
with wheel chocks to prevent
accidental carrier movement.
Check the area around the
carrier and the equipment to
be loaded for obstructions or
hazards.
7. Slide the deck back. Align the
arrow decal pointer on the side
of the deck with the deck control
switch in the control panel.
8. Raise the front of the deck until
the rear bumper rests firmly on
the ground.
Tilting the deck too soon
may cause damage to the
mechanical hold down.