19
3.3.5 Faceplate Installation
1.
Remove the faceplate panels from the packaging and assemble according to the following
instructions:
2.
Using two (2) screws, fix the upper faceplate panel onto the faceplate frame pre-mounted on
the insert (Figure 13).
3.
Using two(2) screws (per panel), install the side panels onto the frame in a way where the side
panels overlaps the upper panel and the bent strip of the side panels slides under the upper
panel(Figure 14).
4.
Secure left and right end of the upper panel to the side panels using one (1) screw each side
(Figure 14).
5.
Attach the left and right brass trim sides to the top trim with the corner brackets supplied
(Figure 15a).
6.
Slip the assembled trim over the faceplate and push the faceplate trim clips between the trim
and the faceplate (two on the top edge and three down each side) (Figure 15b).
7.
Push the burner switch through the hole in the front right hand faceplate and connect the
switch to the gas valve (Figure 16 & 17).
8.
***The faceplate frame is attached to the unit with four (4) screws, when loosen the frame can
be move front to rear for faceplate adjustment (Figure 14).
9.
Push the insert into the fireplace opening until the faceplate trim is sealed against the fireplace
facing.
Figure 13
Figure 14
Summary of Contents for SATURNA
Page 7: ...7 2 2 Lighting instructions...
Page 17: ...17 Figure 11...
