17
17
17
17
In the firmware upgrade menu, you can check the current system information such as IP Address, Firmware
Version, MCU Version, Maximum users and No. of current users.
Firmware upgrade can be done with the following steps.
1. Click “Select” button to find a firmware file.
2. Click “Upload” button to upload the selected firmware file to OR-iNVR.
3. When the “Write” button is clicked, firmware upgrade starts.
Note
Do not turn off the power of OR-iNVR while it is being upgraded. Otherwise, it may cause
serious damage on the system.
Note
Firmware upgrade status can be checked through the progress bar.
If it is stopped and there is no more progress for about 10 minutes, close the browser and
reconnect to OR-iNVR. And then, try again.
If the network of OR-iNVR is set as DHCP, IP address might be possible to be changed and
the connection cannot be made. In that case, please check the IP address of OR-iNVR.
Note
Firmware upgrade can be made by CMS software, either.
3.5.6. Factory Default
User can make OR-iNVR to factory default.
Factory default can be made with the following steps.
1. Enter Admin Password.
2. If you want to keep the current network configuration after making factory default, check “Keep
Network Configuration” box.
3. When the “Reset” button is clicked, OR-iNVR starts factory default.
Note
All the configuration data will be lost with Factory default .
If “Keep Network Configuration” box is not checked before starting factory default, current
network setting will be disappeared either.
Note
Factory default doesn’t delete saved data.
If you want to delete all data, you need to format HDD and start factory default.
3.6 Log
User can search System Log and Event Log.
3.6.1. System Log
User can search system log such as ‘Video Loss’(disconnection of IP camera), Connection history, Log-in
history and so on.
Set time to search and click “Search” button to start log search.
3.6.2. Event Log
User can search event log such as Video Loss(disconnection of IP camera), Sensor detection, Motion
detection and so on.
Set time to search and click “Search” button to start log search.
