13
13
13
13
3.2.2. Event Setup
Set Sensor, Motion, Alarm Out(relay) & Video Loss options in this menu.
1. Sensor Assignment
A. Link sensor to each channel.
B. If a certain channels are selected for each sensor, those channels are linked with the sensor.
C. Sensor detection recording time follows the set in the Record Duration and the unit is Minutes.
D. It works only when the recording schedule is set as “Sensor” or “ Sensor”.
2. Motion Detection
A. Set motion detection function on each channel.
B. Only works when recording schedule is set as ‘Motion’ or ‘ Sensor’.
C. To use this, IP camera should have motion detection function and notify it to OR-iNVR.
3. Relay Assignment
A. Set relay output on OR-iNVR.
B. When event triggered in channel, relay output works.
C. To use this, IP camera should have event function(motion detection, sensor detection, video
loss and so on).
4. Video-Loss & Miscellaneous Event
A. Alarm triggers when OR-iNVR & IP camera connection is unavailable due to some reasons.
B. In case of IP camera, when the network is disconnected by some reason, it regards it as Video
Loss.
NOTE
In case of Event Setup, changes will be saved individually.
That is, “Save” button of each function should be clicked before move to another page.
3.2.3. Notification
Set event notification function for when event triggered in OR-iNVR.
Event notification goes through e-mail & network(remote).
In order to notify event through network, IP address of the PC, that will receive the notification, should be
designated and the remote software should be running in the PC.
1. EVENTS : Select event to be notified. It is applied to both e-mail & network(remote) notification.
2. E-MAIL NOTIFICATION : It is set for e-mail notification.
A. ON/OFF : Check whether you use this function or not.
B. SERVER : Enter server to send mail.
C. SMTP PORT : Enter SMTP port of server to send mail.
D. ID : Enter ID that is registered in the server to send mail.
E. PASSWORD : Enter Password of the ID.
F. SSL : Select it if the mail server uses SSL encryption.
3. BUZZER : Check whether you use built-in buzzer when the event triggered or no.
4. REMOTE NOTIFICATION : It is set for network notification to the remote software.
A. ON/OFF : Check whether you use this function or not.
B. SERVER : Input IP address of the PC which will receive the notification. The remote software
should be running in the PC.
