3.
Disconnect the expansion cable plug from the input port on the Module Controller.
4.
Disconnect the expansion cable plug from the output port on the Module Controller
of a library with a tape capacity of greater than 300 tapes. This action applies to
Module 6 through Module 10.
5.
Pinch the latch tabs and pull the latch towards you.
6.
Pull the controller card out of the module slot.
7.
Set the Module Controller on the anti-static work surface.
Replace the Module Controller
The Module Controller latches in to the upper-right rear of the Expansion Module.
Caution:
ESD damage. Do not touch any electronic components or electrical contacts.
1.
Remove the replacement module controller from the ESD packaging.
2.
Grasp the Module Controller without touching components or electrical contacts,
and open the retaining latch.
3.
Insert the Module Controller, component side up, into the module slot.
4.
Seat the latch in the slot to secure the Module Controller.
5.
Connect the expansion cable input plug to the Module Controller input port.
6.
Connect the expansion cable output plug to the Module Controller output port. This
applies to libraries with tape capacity greater than 300 tapes (Module 6 through
Module 10). You must remove the dust cover from the output port.
For cabling, see
.
Chapter 10
Module Controller Removal and Replacement
10-11