Oracle SPARC T5-2, Service Manual

Page: 111 / 186

Enable and Verify Newly Installed DIMMs
g. Switch to the system console and type the Oracle Solaris
fmadm faulty
command.
# fmadm faulty
If any faults are reported, refer to the diagnostics instructions described in “Check for
Faults” on page 46 .
5. Switch to the Oracle ILOM command shell.
6.
Run the
show faulty
command.
-> show faulty
Target | Property | Value
--------------------+------------------------+-------------------------------
/SP/faultmgmt/0 | fru | /SYS/MB/CMP0/MR1/BOB1/CH0/D0
/SP/faultmgmt/0 | timestamp | Dec 14 22:43:59
/SP/faultmgmt/0/ | sunw-msg-id | SUN4V-8000-DX
faults/0 | |
/SP/faultmgmt/0/ | uuid | 3aa7c854-9667-e176-efe5-e487e520
faults/0 | | 7a8a
/SP/faultmgmt/0/ | timestamp | Dec 14 22:43:59
faults/0 | |
If the
show faulty
command reports a fault with a UUID go to Step 7 . If
show faulty
does not
report a fault with a UUID, you are done with the verification process.
7. Switch to the system console and type the
fmadm repair
command with the UUID.
Use the same UUID that was displayed from the output of the Oracle ILOM
show faulty
command.
# fmadm repair 3aa7c854-9667-e176-efe5-e487e520
Servicing Memory Risers and DIMMs 111