Fine Tune the VLAN Setup
Port-and-Protocol Based Support : Enabled
Default Priority : 0
Dot1x Protocol Tunnel Status : Peer
LACP Protocol Tunnel Status : Peer
Spanning Tree Tunnel Status : Peer
GVRP Protocol Tunnel Status : Peer
GMRP Protocol Tunnel Status : Peer
IGMP Protocol Tunnel Status : Peer
Filtering Utility Criteria : Default
Port Protected Status : Disabled
Configuring In-Band Management
Typically, you can access the Oracle ILOM interface within the switch through the NET MGT
port. By configuring in-band management, the Oracle ILOM interface becomes accessible
through one of the 24 10 GbE ports. The NET MGT port remains active, and simultaneous
access to Oracle ILOM is possible.
■
“Requirements for Configuring In-Band Management” on page 23
■
“Configure In-Band Management” on page 24
Requirements for Configuring In-Band Management
These requirements must be met to configure in-band management:
■
In-band and NET MGT networks must be in different subnets.
■
Configure DHCP on only one of the interfaces. Otherwise, the switch receives two default
routes.
■
Configure one IP gateway only. You can configure the IP gateway using either network
management or in-band settings. The IP gateway setting of the other gateway must be set to
0.0.0.0
.
Note -
If the IP gateway is changed to another subnet, the current
ssh
session stops
responding.
■
On the in-band network, ports used to connect to the switch must be in the default VLAN.
No other configuration is required in SEFOS.
Note -
If SEFOS has an IP address on a L3 VLAN interface in the same subnet, you might see
ICMP error messages.
Late-Breaking Information
23
