Known Issues
Switch Might Get Stuck at
uboot
on SSD Related
Error (16922931)
There is a very small chance when a switch is rebooted that it could hang while loading the
kernel image early in the boot cycle. If the hang happens, you see a register dump appear on the
console.
Workaround:
Reboot the switch. If rebooting does not correct the problem, initiate a service
call.
Loss of Access to Management Node Oracle ILOM
When Starting or Resetting the System (16893765)
When using the sideband feature on the Oracle ILOM X4170-M2/ZFSSA-controller to connect
to the management network through the Oracle Switch ES1-24, the port might not link up after
the host is shut down. This issue results in loss of access to the node.
Workaround:
Explicitly set the speed to 100 Mbps on the switch port where the X4170-M2/
ZFSSA-controller is connected. For example, if the port is being used in
ex 0/2
, run these
commands to set the speed to 100 Mbps.
SEFOS#
config terminal
SEFOS(config)#
interface extreme-ethernet 0/2
SEFOS(config-if)#
shutdown
SEFOS(config-if)#
speed 100
SEFOS(config-if)#
no shutdown
SEFOS(config-if)#
end
SEFOS#
write startup-config
CPU Hang on Power Up (16822073)
During a power cycle, it is possible that the CPU might not power-on. If this rare case occurs,
all front panel LEDs remain off and nothing is displayed on console output.
Workaround:
Power cycle the system again. If the problem reoccurs, initiate a service call.
30
Oracle Switch ES1-24 Product Notes • November 2016
