Postinstallation
After the Solid State Drive has been installed in the Acme Packet 4600, you can close
the chassis and reinstall it in the equipment rack.
Attaching the Lid
Use a #2 Phillips-head screwdriver for all chassis cover and side screws.
1.
Set the lid on top of the Acme Packet 4600 chassis. The stickers are positioned at
the chassis rear.
2.
Screw the eight countersunk screws into the top of the Acme
Packet 4600 to secure the chassis cover to the chassis. The
following is an image of the top of the chassis without any
screws.
3.
Continue securing the chassis lid with four screws on each side.
Installing the Chassis in the Rack
Perform the reverse of the operations in the Physical System Removal section of this
document.
Please refer to earlier sections of this document for full rack installation procedures.
Chapter 6
Upgrading or Replacing a Solid State Drive
6-25