To remove a power supply
from the Acme Packet 4600 chassis:
1.
Remove the power cables from the power
supplies.
2.
With your thumb, push the grey locking tab to the left to unlock the power supply
from the chassis.
3.
Holding the handle, pull the power supply towards you. This will disengage the
power supply from the midplane and the chassis.
4.
Continue pulling the power supply towards you until it is completely out of the
chassis.
5.
Move the power supply to an ESD-safe location.
Note:
NEVER power up a power supply before it is installed in the Acme
Packet 4600 chassis.
6.
Ground yourself with an ESD wrist strap before installing a power supply.
Installing a Power Supply
To install a power supply in the Acme Packet 4600 chassis:
1.
Locate the power supply to be installed.
2.
Locate the empty power supply slot in the chassis.
Chapter 6
Power Supply Removal and Replacement
6-9