• MasterPress EMD has electronic panels, heater and electric motors, designed
to be operated in office conditions. Both the equipment and the packaging
must NOT be stored outside or expose to rain, damp, or moisture.
• If the equipment is exposed to rain, damp, moisture or flood, it is
necessary to have the equipment inspected and serviced to avoid the risk
of fire or electrocution!
• The equipment can be transported and stored in low or high temperatures.
• If stored in low temperatures, before switching on, it is recommended that
you leave the equipment in a room at normal temperatures for a day to
avoid condensation on electric circuits coursing damage and electrical
shock.
• The packaging protects the equipment against light knocks and low
vibration, but careful handling is recommended.
• For transportation purposes, the equipment has been attached to a wooden
pallet. Because of the weight moving the equipment by a pallet trolley is
required.
• MasterPress EMD comes with metal lifting handles, which should be
attached as shown in the diagram below, by 6 mm Allen key socket head
bolts in the pre-drilled and tapped holes, to lift the equipment when
assembling and fitting it on to the stand/legs.
• During transportation, the EMD must have the heater head lowered on to the
table with a sheet of thick card between the head and the table to protect
the paint and the heater against damage.
Due to the high, weight and dimensions of the device. Carrying it requires 3
or 4 people in accordance with Health and Safety regulations. The equipment
comes with 2 lifting handles which must be bolted in place to lift, as shown
above.
MasterPress EMD DEEP • User Guide
EN
4 TRANSPORT AND STORAGE
26
rear carrying handle (short)
(+ 2x hex screw M8-20)
front carrying handle (long)
(+ 2x hex screw M8-20)
Transportgriff
(+ 2x Inbusschraube M8-20)
Transportgriff
(+ 2x Inbusschraube M8-20)