5. Now slide the end locks up to each side of the inserted text or matrix/logo
in the frame and tighten the screws to lock in position.
6. When replacing or changing typeface fonts, loosen the end lock screws,
and slide aside the end locks to easily remove the typeface fonts.
7. Now insert the O.SINGLE FRAME MP01/MPEMD or O.FRAME MP01/MPEMD into
the O.MASTER FRAME MP01/MPEMD using the tongs supplied.
Ensure your text and matrix/logo are arrange symmetrically.
Attention!
The holes and the engraved letter or numbers on the back of the typeface
font allows you to distinguish if the letter is the correct way up. The hole at
the bottom is bigger and closer to the edge.
Attention!
During cooling of the O.MASTER FRAME MP01/MPEMD, put it on the special
carrier then you can remove the O.SINGLE FRAME MP01/MPEMD or O.FRAME
MP01/MPEMD and put it on its own carrier to arrange and change the type-
face fonts. BURN HAZARD after making the changes, replace them into the
O.Master Frame MP using the tongs supplied. Always use the plastic handles
on the O.MASTER FRAME MP01/MPEMD to move it.
8. When changing the position spacers in the O.Master Frame MP to make
them move easer loosen the two screws. When tightening the screws do
it gently to lock in position.
Matrix’s and logos
Smaller matrix like O.MATRIX MP01/MPEMD a thickness of 10 mm are mounted
di rectly on to the
O.MASTER FRAME MP01/MPEMD and locked in by the stop bars.
The largest Matrix that is available is fitted directly on to the heater head, with
the O.MATRIX FRAMEWORK MP01/MPEMD. fitted with its own plastic handles.
O.MATRIX MP01/MPEMD with a thickness of 6 mm are made with holes so they
may be screwed to the O.SCREW MATRIX BASE MP1/MPEMD with handles.
ramka O.Master Frame MP
ramka O.Frame MP
z ogranicznikami ramki
ramka O.Single Frame MP
z ogranicznikami ramki
matryca O.Matrix MP
skala pomocnicza
ogranicznik ramki Master
uchwyty
O.Master Frame MP
O.Frame MP with end stops
O.Single Frame MP
with end stops
O.Matrix MP
scale
O.Master Frame MP stops
plastic handle
35
