MasterPress EMD DEEP • User Guide
EN
6. Wait until the heater reaches the desired temperature after switching on
it will take a few minutes.
7. When the desired temperature on the heater is reached the device is ready
for operation.
Attention!
The pre-set temperature of 100°C, which provides in most cases the correct
effect for hot print stamping with Opus products. It is recommended when
hot print stamping covers to do it when the heater reaches the pre set tem-
perature. (when possible always do a test to ensure the best results).
8. When using individual sheets of foil, place the foil over the area to be hot
print stamped on the cover and then slide it under the heater.
9. Press and hold the START buttons until the matrix touches against the
material, after the cycle starts let go of the buttons. When the hot print
stamping process has finished the heater head raises to the pre set
height.
10. When using rolls of foil, the foil will be automatically wound on to the pre
set value.
11. Remove the cover (you may need to gently detach the cover from the foil)
Attention!
When changing text/matrix, place the frame on to the frame carrier WARN-
ING: BURN HAZARD, wait 10-15 minutes until it has cools down. Now you can
start preparing the new text.
Attention!
Recommended settings: Temperature: 100°C / Time 1 second / Pressure 5
These setting provide the most effective results in most cases for hot print
stamping. However, since the settings depend on the type of foil and the sur-
face on which hot print stamping is done, it may be necessary to adjust
the settings. When the foil does not adhere enough, you can increase the
temperature, pressure or time of stamping. If the edges are not clean, reduce
the parameters. You should adjust first the pressure then time of stamping and
last temperature.
Sliding the table out
Changing the cover is made easer by sliding the table out with the handle
at the side of the table, after positioning the new cover, slide the table back.
38
