Attention!
Width of the roll of foil should not exceed 230 mm. It is recommended to use
foil supplied by OPUS, the use of cheaper types of foil and tinsels may not be so
effective and give a inferior effect and not prove satisfactory for your customers.
Please see our full range available on www.opus.pl/en or ask your supplier.
Attention!
If you are using sheets of foil and the wind on motor is installed, you must set
the wind on parameter to 0, otherwise after each stamping an error message
(“Fa”) will appear (SEE ERROR CODES).
4. Using the magnetic stops provided, you can position the cover properly under
the heater.
Make a few tests on scrap material to be sure and readjust the stops if necessary.
To make it easer to position the material you can slid the table out from under the
matrix/heater head.
Attention!
There is no need to insert anything under the cover/project. The EMD automati-
cally finds and adjusts to the correct height under the heater and to the height
and amount of material.
5. Setting the stamping pressure, is done in increments of “0.5”. From 0.5
to a maximum of 10. The proper stamping pressure depends on the size
and type of material and depth required.
Attention!
Automatic repeat setting for die cutting are 10x2 and 10x3 depending on what
you want and how big the die is and how thick the material is you want to cut
a window in.
37
back stop guide
side stop guide
locking screw
locking screw
printing bed
Hintere Abgrenzungshilfe
Seitliche Abgrenzungshilfe
Verschlussschraube
Verschlussschraube
Druckunterlage
