OPTIMUM
M A S C H I N E N - G E R M A N Y
Version 1.0.1 dated 2018-01-31
Page 64
Translation of the original instructions
TM4010 | TM4010D
GB
T
M
4010_
T
M
4010D_G
B_5
.f
m
6.3
Lubricating and cleaning the lathe chuck
ATTENTION!
Do not use compressed air to remove dust and foreign substances from the lathe chuck.
Coolant squirts on the lathe chuck and removes the grease from the master jaws. In order to
maintain the tensioning force and the long-term accuracy of the lathe chuck, the lathe chuck
must be lubricated regularly. Insufficient lubrication will result in malfunctions at reduced ten-
sioning force, which affects the accuracy and causes excessive wear and seizing.
Depending on the chuck type and operating state, the tensioning force of a lathe chuck can
decrease by up to 50 percent of the nominal tensioning force. A presumably securely clamped
workpiece can then fall out of the chuck during processing.
Lubricate the lathe chuck at the worm and at the lubricating nipple. Lubricate the lathe chuck at
least once per week. The used lubricant should be of high quality and provided for high pres-
sure bearing surfaces. The lubricant should withstand the coolant and other chemicals.
Numerous different lathe chucks are available on the market which distinguish themselves con-
siderably based on the lubricating method. Follow the operating instructions of the correspond-
ing lathe chuck manufacturer.
6.4
Repair
6.4.1
Customer service technician
For any repair work request the assistance of an authorised customer service technician. Con-
tact your specialist dealer if you do not have customer service's information or contact Stürmer
Maschinen GmbH in Germany who can provide you with a specialist dealer's contact informa-
tion. Optionally, the
Stürmer Maschinen GmbH
Dr.-Robert-Pfleger-Str. 26
D- 96103 Hallstadt, Germany
can provide a customer service technician, however, the request for a customer service techni-
cian can only be made via your specialist dealer.
If the repairs are carried out by qualified technical personnel, they must follow the indications
given in these operating instructions.
The company Optimum Maschinen Germany GmbH does not take any liability nor does it guar-
antee against damage and operating malfunctions resulting from failure to observe this operat-
ing instructions.
For repairs, only use
faultless and suitable tools only,
only original parts or parts from series expressly authorised by Optimum Maschinen Ger-
many GmbH.
