Optimum 3346245, Operating Manual

Page: 46 / 120

Operation
Version 1.0.4 - 2020-07-31 46 Translation of the original instructions
MZ4S GB
MZ
4S
_G
B_4.
fm
4.16 Optional compressed air tool clamp of the vertical spindle
The pneumatic tool clamp can only be used when the spindle guard is open.
ATTENTION!
Loosening the tool when the spindle is running out can
lead to damage.
Wait until the spindle stops completely before pressing
the tool release button.
Functionality: The tightening rod of the tool is driven by an air
motor and rotates the tightening rod into the threaded hole of
the tool holder. To release the tool, the tightening rod is
turned back out of the threaded hole of the tool holder.
The compressed air tool clamp for turning the tightening rod
in and out can only be operated when the spindle guard is
open.
Shift the morse taper fixture into the spindle of the milling
machine.
Press the clamp or release button (2) to clamp or unclamp
the tool.
INFORMATION
If necessary, the tightening torque of the air motor can
be reduced.
This adjustment option (3) is located under the cover
cap of the compressed air wrench.
The factory setting was set to the number 6. Make sure
that compressed air with 6.2 bar is available.
4.17 Conversion to horizontal milling

Loosen the hexagon screws (1) and hexagon socket screws (2).

Swivel the vertical milling head aside (3) and move backwards on the rail.

Assemble the protective cover (4) from the accessories of the toolkit for the spindle drive
"Vertical milling".
1
2
3