HiScan Touch
Installation and Operation Manual
OPTIKON 2000
Code 14101XEN
6-6
2014-09-02 Rev.B
6.7 UPDATING THE DEVICE SOFTWARE
HiScan is supplied ready for use. The software is directly installed by the
manufacturer.
The device is however supplied with a CR-ROM that includes the complete release
of the software and can be used for maintenance or to reinstall the HW updates.
The CD-ROM contains in particular the board drivers and the HiScan software. The
installation instructions of the software are usually printed directly on the CD-ROM.
In all cases the installation procedure is the following:
•
Remove previous versions of the HiScan software, if existing (uninstall the
software by following the appropriate procedure in the control panel of
Windows XP or Windows 7 – Add programs).
•
During startup the new hardware will be automatically detected and the
operator will be prompted for the applicable drivers: insert the installation CD
in the reader, and select the folder "XPInstall" which contains the required
drivers. Wait until the hardware installation procedure automatically finishes.
•
Only at this point, it is possible to install the HiScan software by launching the
program Setup.exe in the installation CD-Rom's main folder (for example,
“D:\setup” if D is the letter designating the CD-Rom drive being used).
•
The software installs automatically. It is therefore sufficient so follow the
prompts and confirm. During the software installation, if the device will be used
by several users, you will prompted to select between a "multi-user" or "single-
user" installation. In the first case the HiScan software will be available to all
the users who logon to the device; in the second case it will be available only
to users who enter the "User ID" and the "Password," if any, that were set
during installation.
•
Restart HiScan. The program will be launched automatically at the end of the
start-up procedure.
