ENGLISH
FRANÇAIS
DEUTSCH
IT
ALIANO
ESP
AÑOL
PORTUGUÊS
EN-9
Detector condition
LED indicator
Warm-up
120 sec.
Alarm
2 sec.
Masking detection
(FTN-RAM only)
Blinks 3 times and then repeats.
Blinks for approx. 120 seconds.
Lights for 2 seconds.
LED
Blink
OFF
Light
CR123A (3 V, 1300 mAh)
CR2 (3 V, 750 mAh)
1/2AA (3.6 V, 1000 mAh)
Approx. 6 years
Approx. 4 years
Approx. 5 years
Approx. 5 years
Approx. 3 years
Approx. 4 years
Interval 5 sec
Interval 120 sec
Notes>>
• The LED blinks even if the DIP
switch 4 (LED) is set to “OFF”.
Notes>>
• Data shown here is when the LED is
off, AM is on. Battery life becomes
shorter when the LED is on.
1
Stacking method
Side-by-side method and
top-to-bottom method
Separate box
Separate
box cover
Separate box
Separate
box cover
Black
Red
3
2
Replace the battery.
3
Connect the connector, and close
the separate box.
Note>>
• Check that the warm-up period
is started.
Open the separate box, and disconnect the transmitter
connector. (It is not necessary for the main unit to be opened.)
5
OTHERS
6
BATTERY
5-1
WALL TAMPER (OPTION) CONNECTION
5-2
LED LIGHT PATTERN
6-1
HOW TO REPLACE BATTERY
6-2
BATTERY LIFE
Mounting position
Stacking method
Side-by-side method and top-to-bottom
method
Separate box side Main unit side
Wall tamper (option)
WRS-03
Bracket
Sponge
Separate
box
Sponge
Connect the tamper connector as shown below
when connecting a wall tamper (option).
The detector shares the battery with the transmitter. Check that the 2.5 to 10.0 V power battery is used for the
transmitter.
The following explains the LED light pattern.
The values indicated are only for reference on condition that the detector is exceptionally operated by the sole battery.
It is impossible to indicate the battery life under the normal operation as the battery in the transmitter is shared with the
detector.
