Online USV ZINTO A 1000, User Manual

Page: 103 / 182

102 / 181
Manual-ZintoA_final_ger_engl_it_20081017.doc
05.11.2008, Dipl.-Ing. S. Spitzley
Output menus and an acoustic signal (1 x every 4 seconds).
In addition, the scale provides information on the accumu-
lator capacity.
ATTENTION:
There may still be a voltage on the output sockets
of the UPS system even if the mains supply has
been switched off or the mains cable has been
disconnected.
9.3 Switching off
The UPS can be switched off from both operating modes.
9.3.1 Switching off in the normal mode
The UPS is switched to the ready mode by pressing until
the acoustic signal stops (approx. 3 sec.). The load is no
longer supplied with power.
To shut the UPS down completely, please disconnect the
mains cable. The fans continue to run for a short time and
then the UPS switches off completely.
9.3.2 Switching off in the battery mode
The UPS is switched off by pressing until the acoustic signal
stops (approx. 3 sec.) and stops supplying power to the load.
9.4 Overload
In case of device overload (load >110%) there is a regular
acoustic signal and
Overload illuminates. Power continues to
be supplied to the loads connected, however the load con-
nected must be reduced without delay.